| Particulars |
CONICAL RAPID MIXER |
| Vessel |
Vertical Conical stationery |
| Vessel Support |
Lugs |
| Charging |
On top cover |
| Discharge |
On bottom of cone or on side of that part, by gravity |
| Rotary Part for mixing |
Inclined screw conveyor, running all over conical inside surface
while rotating |
| Drive & Position |
Motor v-belted to heli-bevel-worm reduction, then geared to screw
conveyor. Another motor for rotating arm on horizontal plane.Drive is
placed on top cover |
| RPM range |
DEPENDING UPON THE CAPACITIES,,750-1700 RPM. |
| Drive lifting |
Not neeeded |
| Suitable for mixing |
Free flowing solid-solid. |
| Liquid spraying |
Possible by providing spray ll ball manifold to the swing arm |
| Homoginiser |
Not required |
| Chopper/ Lump breaker |
Can be provided near the apex of cone |
| Jacketing |
Possible |
| Vacuum |
Possible |
| Vac. Sealing |
Mech seal, proper sealing is possible due to stationery vessel |
| Air filter |
Air Vent on Topcover |
| Manhole |
On top cover/Charging hole itself |
| Mixing time |
15-20 minutes |
| Drying time For 20% Vapour content |
18-230hrs |
| Baffling |
Flats between flights |
| Mixing method |
Conveying up, tumbling down in inclined manner |
| Precision of Mixing |
Three dimesional, Quite precise even for a small sample and
addition |
| Suitable for product |
Dry powder, drying of centrifuged cake |
| HP rating |
80-90% efficiency |
| Space occupancy |
cone occupies vertical space but less horizontal, and can be suspendedform
above floor into below ground |
| Safety Factor |
Rotor is totally enclosed, no lifting of drive, hence safe. |
©
Srinidhi Engineers, Mumbai. All Rights Reserved (Terms
of Use)